Removable
Mounting Plate
© 2006, MotorGuide
For questions, contact Consumer Affairs at 1-920-929-5040
www.motorguide.com
90-8M4000705
Instruction Sheet
MGA501A1 Removable Mounting Plate
These instructions detail directions concerning mounting and usage of the removable mounting plate.
Kit Contents
• 1 Outer plate
• 1 Inner bar
• 1 Assembly pin
• 1 Hardware package
⌐2 ¼-20x15/8lengthPhillipspan-headscrew
⌐4 ¼-20x1½lengthPhillipspan-headscrew
⌐6 ¼-20x1lengthPhillipspan-headscrew
⌐6 ¼-20x2½lengthPhillipspan-headscrew
⌐18 flatwasher
⌐12 ¼nylocknut
⌐1 lock-ringpin
Mounting Instructions
Step 1. Remove the trolling motor from the mount.
Step 2. Remove the mount from the boat deck. Retain the hardware from this step. DO NOT THROW AWAY. Note the position of
themountonthedeckandhowfarthemountextendspastthegunnel.
Step 3. Assemble the outer plate and inner bar. Insert the assembly pin through hole dtosecurethetwopieces.Positionthe
assemblyontheboatdeck.Placethemountontopoftheassemblytoensureproperpositionofthemount.
(Dropintwopins/screwsifnecessarytokeeptheinnerbaralignedwiththeouterplate).Removethemountwhilehold-
ing the assembly in position. Mark the location of the inner bar holes onto the boat deck. Remove the assembly and drill a
5/16”holeinthemarkedlocations.
Step 4. Attach the outer plate to the bottom of the mount using the appropriate holes as indicated above.
Note: The 07 mount (36” length) may require an additional set of holes drilled into the base of the mount.
3.1 Gator Flex: Usethe15/8”lengthand1½”lengthscrewsalongwiththewasherand
lock nuts.
3.2 Gator 20 Series (07, 16 mount): Usethe1”lengthscrewsalongwiththewashersandnylocknuts.
Step 5. Attach the inner bar to the boat deck.
4.1 If your original mount DID NOT use rubber mount isolators, then re-use hardware from Step 2.
4.2 IfyouroriginalmountDIDuserubbermountisolators,discardthemandusethe2½”screwswithwashersand
lock nuts.
Step 6. Set the mount, with its attached outer plate, over the secured inner bar. Slide the mount backwards to
engage the lip on to the inner bar.
Step 7. Slide the assembly pin through the outer plate and inner bar (through hole d).Securetheassembly
pin by inserting the lock-ring pin through the end of the assembly pin.
Step 8. Install the trolling motor back onto the mount. Check for proper orientation at both the stowed and
deployed positions.
Comments to this Manuals